GE JSP42CKCC Dimensions And Installation Information

JSP42WK/CK/BK
GE 30" Slide-In Electric Range
®
Dimensions and Installation Information
Models are shipped with color-
KW Rating
matched Rear Filler Strip Kit.
240V 10.8
Optional Kits For Slide-In
Electric Ranges
208V
8.1
(Available at additional cost)
Lower/Side Trim Kits Accessory Backguards
JXS56 - Lower Trim Kit
JXS86 - Vertical Side Trim Kit
Note: To reduce possiblity of scorching of the side wall
adjacent to the heating elements, it is recommended
a minimum of 6" spacing from adjacent side walls
be allowed for possible extended, high-heat, no-load
operation of heating elements.
Receptacle Location: For all 30" Slide-In Ranges locally
approved flexible service cord or conduit must be
used because terminals are not accessible after range
installation. See shaded area in drawing for location of
electrical outlet box. Recommended outlet locations
allow range to be installed directly against rear wall.
Note: Cabinets installed adjacent to slide-in ranges
must have an adhesion spec of at least 194°.
Installation Information: Before installing, consult
installation instructions packed with product for
current dimensional data.
For answers to your Monogram, GE Profile
®
GE appliance questions, visit our website at
®
ge.com or call GE Answer Center
®
800.626.2000.
JXS37 - Backguard
JXS77 - Body Sides
If you are NOT using the
optional Filler or Backguard:
11.1%
or
™
service,
If you are using the optional
Filler or Backguard:
23-3/16
30
Dimension and installation information are shown in inches.
25
30
All GE ranges are equipped with
an Anti-Tip device. The installation
of this device is an important,
required step in the installation
of the range.
Specification Created 11/04
Listed by
Underwriters
Laboratories
R
320644