GE JAP02SNSS Owner's Manual And Installation Instructions page 37

INST ALL THE RANGE
8
REPLACE THE WIRE COVER
Replace the wire cover on the range back
by replacing the two screws removed
earlier. Make sure that no wires are pinched
between the cover and the range back.
2 screws
to remove
wire cover
Back of Range
9 ANTI-TIP DEVICE:
To reduce the risk of tipping the range,
the range must be secured by a properly
installed anti-tip bracket. See installation
instructions shipped with bracket for complete
details before attempting to install.
To check the bracket is installed and engaged
properly, carefully tip the range forward. The
bracket should stop the range within 4 inches.
If it does not, the bracket must be reinstalled.
If the range is pulled from the wall for any
reason, always repeat this procedure to verify
the range is properly secured by the anti-tip
bracket.
If your range has no ant-tip bracket, call
1-800-626-8774 to receive one at no cost
Installation Instructions
Wire cover
WARNING!
ANTI-TIP DEVICE
ALL RANGES CAN TIP
BURNS OR OTHER SERIUS
INJURIES CAN RESULT
INSTALL AND CHECK THE
ANTI-TIP BRACKET
FOLLOWING THE
INSTRUCTIONS SUPPLIED
WITH THE BRACKET
.
10 REMOVE STORAGE DRAWER
Pull the drawer out until it stops.
A
B Lift the front of the drawer until the
stops clear the guide.
Remove the drawer.
C
37
Stop