SECTION 4
CUB CRAFTERS
NORMAL PROCEDURES
CC11-100
In hot and high conditions, especially above 3,000 feet, it
is important to lean the mixture prior to the magneto
check. To do this, apply full power. Slowly lean the
mixture until you observe the peak RPM. Retard the
throttle slowly and proceed with the rest of the run-up.
Prior to takeoff, verify that the flight instruments operate
correctly. Ensure that the fuel selector is on BOTH, the
mixture is set, and the carburetor heat in the cold
position. Engine gauges should be in the normal ranges.
Flaps should be selected for takeoff; first notch (15°) is
recommended. The door should be closed and seat belts
fastened.
REPORT SC10000AFM
Issued: 08/01/06
Page Number: 4-22
Date of Revision: 11/23/18