Approach And Landing - Cub Crafters CC11-100 Pilot Operating Handbook

CUB CRAFTERS
CC11-100

4.3.3.6 Approach and Landing

4.3.3.6.1 Normal Landing
•
Fuel Selector ......................................................... Both
•
Seat Belts ...................................................... Fastened
•
Mixture ..................................................................... Set
•
Flaps ........................................................................ Set
INDICATED AIRSPEED (IAS)
Maximum speed first notch flaps (15°)
Maximum speed (>15°)
•
Trim ......................................................... As required
•
Speed ......................................................... As required
(1.3 times full flaps stall speed at gross weight is 42 mph or
36 knots IAS)
•
Doors and windows ........................................... Closed
4.3.3.6.2 Crosswind Landing
• Fuel Selector ...................................................... Both
• Seat Belts ................................................... Fastened
• Mixture .................................................................. Set
• Flaps ........................................... Set below white arc
INDICATED AIRSPEED (IAS)
Maximum speed first notch flaps (15°)
Maximum speed (>15°)
• Trim ......................................................... As required
• Speed ...................................................... As required
(A higher speed than normal is recommended)
• Ailerons-Rudder ...................................... On short final
• Touchdown .... Do not drift sideways during touchdown
• Landing Roll ............. Use ailerons to keep upwind wing
Issued: 08/01/06
Date of Revision: 11/23/18
NORMAL PROCEDURES
Use ailerons to keep upwind wing low
Rudder to hold runway alignment
REPORT SC10000AFM
SECTION 4
MPH KNOTS
85
81
MPH KNOTS
85
81
Page Number 4-13
74
70
74
70