CUB CRAFTERS
CC11-100
4.3.2.2 Starting Engine
•
Master Switch ....................................................... On
•
Mixture ........................................................... Full rich
•
Primer .............................................................. Apply*
•
Throttle ................................................ Open 1/2 inch
•
Starter ........................................................... Engage
After engine has started:
•
Oil Pressure ..................................................... Check
•
Throttle ................................................. Set 1000 rpm
•
Ignition Switch .................................................... Both
•
Lights ....................................................... As required
•
Avionics Master Switch ......................................... On
*Normal procedure three times. If engine is hot, omit this step.
ENSURE THAT THE PRIMER IS CLOSED AND
LOCKED AFTER THE ENGINE HAS STARTED.
APPLYING THE PRIMER WITH THE ENGINE
RUNNING WILL MAKE THE ENGINE STOP.
4.3.2.3 Starting Engine when Flooded
•
Mixture ...................................................... Idle cut-off
•
Throttle ....................................................... Full open
•
Starter ........................................................... Engage
When engine fires:
•
Mixture ................................................................ Rich
•
Throttle ....................................... Retard to 1200 rpm
•
Ignition Switch .................................................... Both
•
Oil Pressure ..................................................... Check
•
Lights ....................................................... As required
•
Avionics Master Switch ......................................... On
Issued: 08/01/06
Date of Revision: 11/23/18
NORMAL PROCEDURES
WARNING
REPORT SC10000AFM
SECTION 4
Page Number 4-9