Engine Failure During Takeoff - Cub Crafters CC11-100 Pilot Operating Handbook

SECTION 3
EMERGENCY PROCEDURES
3.3.2

ENGINE FAILURE DURING TAKEOFF

PRIOR TO LIFT-OFF
Maintain directional control
Throttle ........................................................................ Idle
Brakes ................................................ Apply as necessary
Wing Flaps ............................................................ Retract
Mixture .............................................................. Idle cut-off
Magneto Switches ........................................................ Off
Master Switch ............................................................... Off
AFTER LIFT-OFF
If sufficient runway remains for a normal landing, land
straight ahead.
If insufficient runway remains:
Maintain a safe airspeed.
Use shallow turns to avoid obstructions.
Use of flaps depends on circumstances. Normally, flaps
should be extended for touchdown.
If there is sufficient altitude to attempt a restart, proceed
as follows:
Maintain safe airspeed
Fuel Selector ............................................................. Both
Mixture .............................................................. Check rich
Magnetos .................................................. Ensure both on
Starter ................................................................... Engage
If restart is unsuccessful, when landing area is assured:
Magnetos ...................................................................... Off
Master Switch ............................................................... Off
Fuel Selector ................................................................ Off
ELT ..................................................................... Activated
Seat Belts ............................................... Tight and secure
Door .......................................................................... Open
Touchdown ...................... At the lowest possible airspeed
REPORT SC10000AFM
Page Number: 3-4
CUB CRAFTERS
CC11-100
Issued: 08/01/06
Date of Revision: 11/23/18