Cub Crafters CC11-100 Pilot Operating Handbook page 220

SECTION 9
SUPPLEMENTS- TWO-SWITCH
ELEVATOR TRIM SYSTEM
simultaneously .................. Movement per aft switch
•
Trim selector switch ........ Set for intended operation
9.5.5.2 BEFORE TAKEOFF
•
Trim selector switch ........ Set for intended operation
9.5.6 PERFORMANCE
No change.
9.5.7 WEIGHT AND BALANCE
If the Two-Switch Elevator Trim System was installed at
the factory, it is included in the licensed weight and
balance information in section 6 of the Pilot's Operating
Handbook. If it was retrofitted to the aircraft, the
installation instructions provided by Cub Crafters will
have the appropriate weight information that should be
included in section 6 of the Pilot's Operating Handbook
9.5.8 DESCRIPTION AND OPERATION
The Two-Switch Elevator Trim System allows either
occupant to operate the elevator trim. There is a selector
switch on the left wing root panel (Figure 2) that has three
positions,
•
FRONT
•
OFF
•
REAR
When the selector switch is in the FRONT position, the
system is biased in such a way that operation by the
forward occupant will override any operation by the aft
occupant.
REPORT SSC100000AFM
Page number 9-5-6
CUB CRAFTERS
CC11-100
Issued: 03/13/12
Date of revision N/A