Cub Crafters CC11-100 Pilot Operating Handbook page 199

CUB CRAFTERS
CC11-100
9.2.3.4 INSTALLATION OF REAR STICK COVER
1. Loosen and remove the AN3 bolt, washers, and
AN365 lock nut holding the rear stick into the rear
stick stub.
2. For first time installation, remove floor fasteners
and install the rear stick cover over the stick stub
and match drill to the existing fasteners on the
floorboard.
3. Fasten the stick cover to the floorboard using
existing hardware from the last step.
Issued: 04/15/09
Date of Revision: 10/31/11
SUPPLEMENT- SINGLE PLACE CONVERSION
SECTION 9.2
REPORT SC10000AFM
Page Number: 9-2-7