Cub Crafters CC11-100 Pilot Operating Handbook page 197

CUB CRAFTERS
CC11-100
9.2.3 CONVERSION PROCEDURES
9.2.3.1 FROM TWO PLACE TO SINGLE PLACE
Remove or stow the rear seat.
Remove the rear stick and install the rear stick stub
cover. Install placard on the instrument panel, overhead
tube near the compass correction card, or in another
conspicuous place. The maximum empty weight in this
configuration is shown in Section 9.2.2.2.
9.2.3.2 FROM SINGLE PLACE TO TWO PLACE
Install rear seat. Remove the rear stick stub cover and
install rear stick (if desired).
governing single place operation only.
maximum empty weight configuration is shown in Section
9.2.2.2.
9.2.3.3 DETERMINATION OF LOADING CHANGE
Use the table below to determine the weight and balance
changes for converting a two place to a single place
aircraft. Use the information in reverse when the aircraft
is returned to service in a two place configuration. Use
only the applicable information (stowing vs. removing
seat).
Item
Rear Seat Removal (includes
seat cross bar)
Rear Control Stick Removal
Rear Control Stick Cover
Table 9-2-2 - Weight & Balance Changes
Issued: 04/15/09
Date of Revision: 10/31/11
SUPPLEMENT- SINGLE PLACE CONVERSION
See Section 9.2.3.4..
Remove the placard
Weight Arm
(lb) (in)
-6.15 96.08
-.20 84.08
.69 84.08
REPORT SC10000AFM
Page Number: 9-2-5
SECTION 9.2
The aircraft
Moment
(in-lbs)
-590.89
-16.82
58.02