Cub Crafters CC11-100 Pilot Operating Handbook page 195

CUB CRAFTERS
CC11-100
9.2.1 GENERAL
This supplement describes the process and requirements
for converting a two place aircraft to a single place
aircraft and provides authorization to perform this
conversion.
regulations, a two place 80hp S-LSA must weigh less
than 902 pounds empty.
pounds (1200 on floats with CC340) applies when the
aircraft has been converted to single place only
operation. The aircraft may be converted back and forth
from single place to a two place configuration as
described in this supplement, as long as it meets the
empty weight requirements for that configuration per
Section 9.2.2.2. This may be useful for owners/operators
to install special equipment such as large tires, skis, etc
but would put them overweight for two place operation.
This supplement allows that aircraft to be converted to
single place.
Operating Handbook and is required for single place
operation.
owner/operator task.
9.2.2 LIMITATIONS
9.2.2.1 GENERAL
The conversion requires the following items:
For Single Place Operation:

Rear seat must be removed or stowed

Rear control stick must be removed

Rear control stick cover must be installed

Single Seat Placard must be installed

Maximum empty weight per Section 9.2.2.2.
Issued: 04/15/09
Date of Revision: 10/31/11
SUPPLEMENT- SINGLE PLACE CONVERSION
In accordance with ASTM and FAA
This supplement supersedes the Pilot's
This conversion
The empty weight of 1090
is considered
REPORT SC10000AFM
Page Number: 9-2-3
SECTION 9.2
an