Cub Crafters CC11-100 Pilot Operating Handbook page 182

SECTION 9.1
SUPPLEMENT-FLOATS
9.1.6.4.4 Preflight Left Fuselage, Wing, and Float

Float Hatches ... .Cargo secure and hatches latched

Main and Nose Gear (Amphibious Only) ....... Check

Float ....Check for damage and water accumulation
Remove rubber plugs which serve as stoppers on the
standpipe in each float compartment and pump out any
accumulation of water. Reinstall rubber plugs with

Bilge Rubber Plugs ...................................... Secure

Fuel Tank ...........Check supply and cap for security

Fuel Cap Vent ............................................... Check

Landing Light ................................. Check condition

Pitot Tube ...................................... Check condition

Stall Warning Vane ........................ Check condition

Wing Tip and Light ......................... Check condition

Vortex Generators ........................................ Check

Aileron Hinges .............................................. Check

Aileron Surface .............................. Check condition

Flap Hinges .................................................. Check

Flap Surface .................................. Check condition

Water Rudder and Cables ............................ Check

Left Fuselage ................................................ Check
REPORT SC10000AFM
Page Number: 9-1-14
NOTE
enough pressure for a snug fit.
(use bilge pump as necessary)
Date of Revision: 04/09/13
CUB CRAFTERS
CC11-100
Issued: 04/15/09