Instrument Panel; Cabin Heat - Cub Crafters CC11-100 Pilot Operating Handbook

CUB CRAFTERS
CC11-100
Figure 9 - Stowage in Sling Seat Holder
The seat cross bar can either be securely stowed in the
aft baggage compartment or reinstalled in the fuselage
cross bar slots. If the cross bar is reinstalled, the nylon
straps must be reinstalled on the cross bar and re-
attached to the floorboard in order to securely hold the
cross bar in place.
7.7

INSTRUMENT PANEL

The instrument panel contains all flight, navigation, and
engine instruments that are required for VFR operations.
See Manufacturer's instructions regarding operation of
equipment installed in the instrument panel.
7.8

CABIN HEAT

Hot air for heating the cabin is supplied by a heat
exchanger located around the engine exhaust. Hot air
enters the cabin through opening in the floorboard. To
select the heater, the control on the upper right part of the
instrument panel must be pulled aft.
Issued: 08/01/06
Date of Revision: 11/23/18
AIRCRAFT AND SYSTEMS
SC10000AFM
REPORT
Page Number: 7-15
SECTION 7