Cub Crafters CC11-100 Pilot Operating Handbook page 155

CUB CRAFTERS SECTION 7
CC11-100 AIRCRAFT AND SYSTEMS
When the rear seat is not in use, it can be stowed in the
Sling Seat Holder. See the Aircraft Maintenance Manual
Section 5.4.15.
Disconnect the two cinched nylon straps holding the seat
cross bar to the floor by unscrewing and pushing in on
the screw. This will allow the tab to rotate and slide the
pin out of the seat base connector. Lift the rear seat
cross bar up and out of the retaining slots. See Figure 6
and Figure 7.
Rear Seat Cushion
Left Side Fuselage
Cross Bar Slot
Right Side Fuselage
Cross Bar Slot
Rear Seat Cross
Bar Sleeves
Cross Bar
Nylon Straps
Figure 6 - Removal of Rear Seat Bar
SCREW
Figure 7 - Disconnecting Nylon Straps
SC10000AFM
Issued: 08/01/06 REPORT
Date of Revision: 11/23/18 Page Number: 7-13