Summary of Contents for SolarEdge SE-RS485-SPD2-K2
Page 1
RS485 Surge Protection Kit for Single Phase HD-Wave Inverter - Installation Guide This document describes how to install the RS485 Surge Protection Kit in the SolarEdge single phase HD-Wave inverter. Kit Contents Surge protection board Standoff Installation Procedure Turn the inverter ON/OFF switch to OFF.
Page 2
RS485 Surge Protection Kit Installation Guide Replace the middle bolt that connects the power board to the chassis with the standoff supplied with the kit (see Figure 3). Replace this bolt with the supplied standoff Figure 3: Bolt that connects the power board to the chassis Insert the surge protection board’s connectors into the communication board socket, applying light pressure (see Figure 4).