Immergas SUPER TRIO TOP Instructions Booklet And Warnings page 62

1.7 CONNECTION WIRING DIAGRAM SINGLE ZONE
HYDRONIC KIT (SECOND ZONE OPTIONAL) AND
MAGIS PRO 12-14-16 V2 INTERNAL UNIT.
Once the kit is assembled, proceed with the wiring according to
the diagram Fig. 19.
- Connect the cables in the Magis Pro 12-14-16 V2 Interna Unit
control panel following the connection diagram in Fig. 23.
- Lower the wiring exiting the Magis Pro 12-14-16 V2 Interna
Unit until it can be secured with the clips (1-2).
- Connect the storage tank probe terminals (4) to the device ter-
minal block / terminal board (see wiring diagram Fig. 23) and
position it on the storage tank in the appropriate seat (Fig. 25),
using the relative cable clamp.
- Connect the flow probe connector (5) to the wiring marked by
the label "SONDA" (PROBE), then connect the wiring to the
probe and connect the "T-SIC" connector to the safety thermo-
stat (Only if the second optional zone is present).
- Connect the connector with the red "M-Z1" label to the pump
/ circulator (7) and connect the wiring terminals to the device
terminal block / terminal board (see wiring diagram Fig. 23).
2 4
2 5
62
- Connect the connector with the green "M-Z2" label to the pump
/ circulator (8) (Only if the second optional zone is present).
- Connect the connector of the mixing valve (6) marked with the
"V.MISC" (MIX.V) label (Only if the second optional zone is
present).
- Connect the antifreeze box connector (9) to the wiring connector
with the "ANTIFREEZE" label, and connect the wiring terminals
to the device terminal block / terminal board (see wiring diagram
Fig. 23).
- Make the connection to the power supply of the Internal Unit
using the cable (3) as shown in the wiring diagram (Fig. 23)
- At the end, group the various cables and join them with the clip
(2) supplied.
Attention: in order for the probes to function properly, before it
is inserted, it is recommended to put a bit of conductive paste on
the relative probe-holder.
N.B.: wind the uncovered fittings with the insulation present
in the kit.
2 1
2 2
2 6
2 3
2 8
2 7
2
9
19
DHW probe - positioning (Det. 4)
20