Immergas SUPER TRIO TOP Instructions Booklet And Warnings page 53

Installation operations.
• Set-up the masonry jobs creating an opening in the wall where
the frame will be installed (D), paying attention to envision the
space for the six slots for inserting the respective support fins
(D2) and a space under the frame sufficient to carry out the kit
connections (Fig. 5).
N.B.: it is very important to provide a support screed in the area
under the Container for Super Trio at the support point of the
storage tank unit.
• It is also possible to fix the frame to the wall with plugs (not
supplied) using the special four holes Ø 8 mm (D1).
D2
D
D2
1
D1
D2
• The Container Super Trio is closed by the side cover (C), where
the air intake grid is present, by the upper cover (B) and by the
door (A) which can be opened by the handle and only after
having unlocked the locks placed vertically to access the thermal
kits and the hydronic unit.
Attention: The installation of the Container Super Trio inside the
wall, must guarantee a stable and effective support to the appliance
it contains. This kit ensures a suitable support only if inserted
correctly (according to the rules of good practice) and positioned
in square with respect to the wall following the instructions given
below, thus guaranteeing the correct functionality of the front
doors. The Container Super Trio is not a supporting structure and
cannot replace the piece of wall removed. It is therefore necessary
to check its correct positioning inside the wall.
D1
2
3
3
4
B
A
5
C
5
53