Tv Antenna Operation - Winegard AIR 360+ Instruction Manual

TV Antenna Operation

First time users must run a channel scan to receive maximum programming.
Ensure the antenna power supply (wall plate) is in the "ON" position and the green
indicator light is illuminated.
A new scan will find any new channels that have been
added in your area as well as finding any channels that
have changed or moved since the last scan.
While the steps to perform a channel scan may vary
between televisions or compatible devices, here are
some general guidelines to follow.
– Using the television remote, select "Menu" and
then "Settings."
– Select "Channel Setup."
– Select "Antenna" or "Air," depending on your TV.
Make sure you are not on "Cable."
– Select "Channel Search" or "Channel Scan."
Keep in mind that steps to perform a channel scan
may vary. If the wording in your TV differs from the
options shown, refer to your TV user manual for help.
Running a channel scan is NOT the same as pressing Channel UP/DOWN on
your remote.
To receive maximum programming, you have to run a channel scan after setting up the
antenna. To keep your channel line-up up-to-date, it is a good idea to run a channel
scan monthly, anytime a channel is lost, and anytime you change locations.
Note: Refer to Gateway manual for operation instructions.
Scan.
Perform Channel Scan:
Select Menu, then
Channel Search
–8–
Watch.
Scan monthly
for programming
updates.
Power indicator light is
green when power is on.
Power button