Power Supply Installation - Gateway - Winegard AIR 360+ Instruction Manual

Power Supply Installation – TV Antenna
Step 5 – If hooking up the antenna to two televisions, connect a coax cable from
the "SET 2" port to the "Antenna In" port on the second television.
If hooking up a cable input, connect the cable input to the "CABLE" port on the
power supply.
Step 6 – Mount the power supply in wall with the provided screws.
Step 7 – Connect a coax cable from the coax port on the front of the power supply to
the "Antenna In" coax port on the main TV.
Step 8 – Press the "ON" switch on the front of the power supply, and check that the wall
plate indicator light is on.
This unit is equipped with a polyswitch, which will shut down +12 VDC if there is a direct
short between the antenna and power supply. The indicator light will not light. Once the
short is eliminated, the device will reset itself.
Power Supply Installation – Gateway
The Winegard Gateway is compatible with the Winegard Air
360 + ONLY. It is the accompanying piece to take your Air
360 + to the next level in connectivity. For more information
please visit winegard.com to find a dealer in your area.
Step 1 – Choose a location to install the supplied Gateway
wall plate with power On/ Off switch. When selecting a
location, remember that a +12 VDC power cable
(10' provided)will need to be run from the Gateway
to the switch.
Step 2 – For a wall or panel mount, drill or use a hole saw
to create a 1¼" hole. Pull the Gateway's power cable
and the RV's power wire through the wall or panel.
Step 3 – Be sure the switch is in the OFF position before
continuing. Slide the power switch into the wall plate.
Step 4 – Connect the +12 V power wire from the vehicle to
a small red terminal insulator. Crimp the connector.
Step 5 – Connect this small red terminal insulator to the
edge spade of the power switch.
Step 6 – Connect the red wire from the Gateway's power
cable to the other small red terminal insulator. Crimp
the connector.
Step 7 – Connect this small red terminal insulator to the middle spade on the switch.
Step 8 –Slide the ground wire from the vehicle into one end of the barrel crimp splice,
and slide the black ground wire from the Gateway's power cable into the opposite
end of the splice. Crimp the splice.
Step 9 – Mount the wall plate to the wall or panel with the 2 supplied wall plate screws.
continued
–7–
GW-1000
On/off rocker
switch (shown
in OFF Position)
+12 V
from
vehicle
Barrel crimp splice
Power
switch into
wall plate
ON
+12 V
from Air
360 +