Power Supply Installation - Tv Antenna - Winegard AIR 360+ Instruction Manual

Installation Instructions
> If planning to install the Winegard Gateway now or at a later time:
Step 6 – Run the 10' Gateway power cable from the hole where the three antenna
cables (yellow, green, and red) enter the ceiling of the RV to the predetermined
location of the Gateway wall plate/power supply. The white connector of this power
cable should be at the same location as the yellow, green, and red connectors. The
Winegard Gateway will use this power cable. The bare wires of this power cable
should be routed to where the Gateway power switch will be installed.
Step 7 – (OPTIONAL) An ethernet cable can be run to the Gateway if hooking to
directly to an ethernet-enabled device such as a smart TV. This will provide better
speed, lower latency, and a more reliable connection.
> If installing the Winegard Gateway now, please review the Winegard Gateway
installation manual followed by reviewing the Power Supply Installation on pages
6 and 7 of this manual.
> If installing the Gateway at a later time continue to Step 8.
Step 8 – Lastly, zip tie the prewire power cable along with the 4G LTE and WiFi cables
to the notch on the backside of the white prewire hole cover. Cut the excess length
of the zip tie off and make sure all the cables are tucked inside the ceiling before
screwing the white prewire hole cover to the ceiling with the 2 provided screws.
Power Supply Installation – TV Antenna
WARNING: The power supply should be turned off when connecting cables.
Coaxial
port for
main TV
Step 1 – The power supply may be flush mounted in most standard electrical boxes. To
flush mount, cut a hole in the wall to fit the box. Run two #12 wires between the wall
plate and +12 VDC source, and route downlead cable to this location.
Step 2 – Make a 12 volt connection from the RV to the power supply. Install the supplied
terminals on wires from +12 VDC source, and crimp the terminals with an appropriate
crimping tool.
Step 3 – Push the wires onto tabs on the back of the power supply. ("PWR" and "GND"
are also noted on the underside of the power supply electronics board).
Step 4 – Connect the coax cable from the antenna to the "ANTENNA" port on the
power supply, and tighten until fingertight. Then, tighten ¼ turn more.
continued
Indicator
light
On/off
button
Antenna
port
Power &
ground tabs
–6–
Set 2
port
Cable
port