Elkay LZ Series Installation, Care & Use Manual page 3

1) Remove hanger bracket fastened to back of cooler by removing one (1) screw.
2) Mount the hanger bracket as shown in Figure 1 (Pg. 2)
NOTE:
(6) 1/4 in. dia. mounting holes.
IMPORTANT:
INSTALLATION OF COOLER
3) Hang the coolers on the hanger brackets. Be certain hanger brackets are engaged properly in the slots on the cooler backs as shown in Figure 1 (Pg. 2).
4) Remove the four (4) screws holding the lower front panel at the bottom of each cooler. Remove the front panel by pulling straight down and set aside.
the trap and tighten securely.
IMPORTANT:
If it is necessary to cut the drain, loosen the screw at the black rubber boot and remove tube, check for leaks after re-assembly.
6) Secure cooler frame to wall by installing (2) screws and washers (not supplied). (See Fig. 2, Pg. 6).
pencil (See Fig. 1, Pg. 2). Place tape over wiring harnes conection on top of cooler to prevent debris from falling into Connection (See Fig. 3, Pg. 6).
9) Remove wall mounting plate from wall. NOTE: Mounting plate MUST
13) Place Bottle Filler on the three (3) angled tabs protruding from the wall mounting plate, installed on wall.
14) Once Bottle Filler is installed on wall plate tabs, push top of Bottle Filler toward wall and line up top cover two (2) holes in wall bracket.
installed.
18) Reinstall two mounting screws from step 7 above (See Fig. 4, Pg. 6). Caution, do not over tighten screws.
cause a sputter. This will be eliminated once all air is purged from the line.
21) Once unit tests out, install Lower Panel back on water cooler(s). Units are now ready for use.
1.) Remove lower cover on non-refrigerated unit by removing (4) screws (See Fig.10, Pg. 8).
2.) Turn off water supply; dispense water to relieve pressure.
Note:
ENLZS8WS_1F
HANGER BRACKETS & TRAP INSTALLATION
7, Pg. 7
Instructions For Replacing Filters
Page 3
Make sure the screws engage in a structural member.
Connect wiring harness to the top of cooler. (See Fig. 8, Pg. 8).
1000002119 (Rev. B- 06/15)