Appendix E: Replacing And Adding System Components; Replacing An Inverter - SolarEdge 3000A-US Installation Manual

Appendix E: Replacing and Adding System
Components
NOTE:
If you are permanantly disassembling the installation or part of it, make sure to use the disposal
methods dictated by local regulations.

Replacing an Inverter

NOTE:
If you remove the old inverter and do not immediately install a new one, then:

Lock the AC/DC Safety Switch in the OFF position using a lock on the switch.

Use insulation tape to isolate each of the AC and DC wires.

Seal the open conduits using duct tape.
1
Turn OFF the inverter ON/OFF switch, and wait until the LCD indicates that the DC voltage is safe
(<50V), or wait five minutes before continuing to the next step.
WARNING!
If you cannot see the inverter panel, or if a malfunction is indicated on the LCD panel, wait five
minutes for the input capacitors of the inverter to discharge.
Si vous ne pouvez pas voir l'écran de l'onduleur ou si un dysfonctionnement est indiqué sur
l'écran LCD, attendez cinq minutes pour que
déchargés.
2
Turn OFF the AC/DC Safety Switch and the AC switch of the main circuit board.
3
Open the inverter cover.
4
Disconnect the DC and AC wires from the inverter and unscrew the two conduit nuts in the inverter
securing the AC/DC Safety Switch to the inverter.
5
Remove the two lower screws securing the inverter to the mounting bracket and remove the inverter
from the mounting bracket.
6
Place the new inverter on the mounting bracket; insert the screws securing the inverter to the
mounting bracket.
7
Connect the DC and AC wires to the inverter and tighten the conduit nuts.
8
Close the cover.
9
Turn ON the AC switch of the main circuit board, the AC/DC Safety Switch and the inverter ON/OFF
switch.
SolarEdge Installation Guide – MAN-01-00002-1.7

Appendix E: Replacing and Adding System Components

les condensateurs d'entrée de l'onduleur soient
67