Connecting A Laptop To The Inverter; Inverter Configuration Menu Options - SolarEdge 3000A-US Installation Manual

The following shows a hierarchical tree of the menu options that appear when using the LCD light
button:
O p t i m i z e r
L a n g u a g e
C o m m u n i c a t i o n
M a i n t e n a n c e
I n f o r m a t i o n
E x i t
Language:
E n g l i s h
G e r m a n
S p a n i s h
F r e n c h
I t a l i a n
E x i t
Communication:
S e r v e r
R S 4 8 5 - 1
Z I G B E E
E x i t
Maintenance:
R e s e t
F a c t o r y
S W U p g r a d e – S D
E x i t
Information:
E r r o r
W a r n i n g
E x i t
The options presented in these menus are described below.

Connecting a Laptop to the Inverter

To connect a laptop to the inverter, use the internal mini-USB connector (type B 5-pin) located on the
inverter communication board (see Figure 27 on page 45). Use a USB to mini-USB cable.

Inverter Configuration Menu Options

This section describes how to use the LCD menus for configuring the inverter. Use either the internal LCD
user buttons or the external LCD light button to move between and select menu options.
Country and Grid
1
Select the Country option to specify the country in which the inverter is installed and the grid to
which it is connected. This parameter may arrive pre-configured. If so, verify that it is set to the
proper country.
WARNING!
The inverter must be configured to the proper country in order to ensure that it functions
properly with that country's grids.
L'onduleur doit être configuré pour le pays approprié afin d'assurer un fonctionnement
convenable avec le réseau de ce pays.
SolarEdge Installation Guide – MAN-01-00002-1.7
p a i r i n g
< e n g >
< L A N >
C o n f < S >
C o n f < S >
C o u n t e r s
R e s e t
C a r d
L o g
L o g
Chapter 6: User Interface
37