Removing The Safety Unit Cover; Creating An Ethernet (Lan) Connection - SolarEdge RESU10H Prime Series Installation Manual

CAUTION!
When removing the inverter cover, make sure not to damage the internal
components. SolarEdge will not be held responsible for any components
damaged as a result of incautious cover removal.
ATTENTION!
Lors du retrait du couvercle, assurez-vous de ne pas endommager les
composants internes. SolarEdge ne peut être tenue pour responsable des
composants endommagés à la suite d'une imprudence dans le retrait du
couvercle.

Removing the Safety Unit Cover

1. Switch off the AC circuit breaker on the main distribution panel and the safety
switch (if applicable).
2. Open the DC Safety Unit cover: Release the four Allen screws and remove the cover.
CAUTION!
When removing the DC Safety Unit cover, make sure not to damage the internal
components. SolarEdge will not be held responsible for any components
damaged as a result of incautious cover removal.
ATTENTION!
Lors du retrait du couvercle, assurez-vous de ne pas endommager les
composants internes. SolarEdge ne peut être tenue pour responsable des
composants endommagés à la suite d'une imprudence dans le retrait du
couvercle.

Creating an Ethernet (LAN) Connection

This communication option enables using an Ethernet connection to connect the
inverter to the monitoring platform through a LAN.
Single Phase Energy Hub Inverter with Prism Technology MAN-01-00842-1.3
Chapter 7: Setting Up Communication with the Monitoring Platform 63