Download Print this page
Moen GEC9 Owner's Manual

Moen GEC9 Owner's Manual

2nd edition guitar effect commander
Hide thumbs Also See for GEC9:

Advertisement

Quick Links

Owner's manual
GUITAR EFFECT COMMANDER
Be sure to read this manual before using the product in order to ensure safe operation.
1

Advertisement

loading

Summary of Contents for Moen GEC9

  • Page 1 Owner’s manual GUITAR EFFECT COMMANDER Be sure to read this manual before using the product in order to ensure safe operation.
  • Page 2 1- Overview Top Panel Rear Panel (1) PRESETS These switches immediately recall the settings stored in the corresponding PRESET 1-5. All the presets are stored in nonvolatile memory, will not be erased even without power supply. (2) MUTE/CLEAN This switch shuts off the LOOP OUT (LOUT1&LOUT2) and switches the INPUT to CLEAN jack, press it again will get back to normal operation.
  • Page 3 (7) BUF IN (Buffered Input) Signal input via this jack is fed to a buffer circuit prior to being sent to the loops. (8) DC Jack 5.5 x 2.1mm negative center, supply with DC 9V. (9) NBUF IN (Non Buffered input) This jack bypasses the buffer circuit and directly sends singal to the loops.
  • Page 4 OUT8 LOOP9 OUT9 Guitar signal feeds into GEC9 input (NBUF IN or BUF IN), enters series loop1~loop6 when MUTE switch is off, then outputs from LOUT1 and LOUT2. If MUTE is on, the signal outputs directly to TUNER jack. The BUF OUT jack always outputs buffered input signal.
  • Page 5: Specifications

    7- Separate loops and Footswitch The separate loops (loop7,8,9) are isolated from each other, with patch cables they can work as either series loops or parallel loops. The send jack and output jack of these loops can also function as latch footswitches which can control amplifiers.
  • Page 6 Configuration 2 - Separate loops as footswitch In this configuration the separate loop send jack S7, S8, S9 are used to control the amplifier channels. The amplifier preamp is connected to GEC9 LOOP1, makes it possible to add modulation effects to the preamp.
  • Page 7 Configuration 4 - Control Pedals in AMP ext. loops Put 6 pedals (Loop1~6) in front of AMP and 3 pedals (Loop7,8,9) into AMP LOOP. Preset 1 example (1=ON, 0=OFF): LP1,LP2...LP7,LP8,LP9 = 1 0 1 0 1 0 1 0 1 Signal flow: Guitar -FX1-FX3-FX5-Preamp -FX7-FX9- Power AMP Preset 2 example (1=ON, 0=OFF): LP1,LP2...LP7,LP8,LP9 = 0 1 1 1 1 1...
  • Page 8 MOEN GUITAR PEDALS www.moenfx.com...