Table of Contents
Advertisement
6
Chapter 1: The SolarEdge Inline Energy Meter with SolarEdge Energy
Net Communications
Chapter 1: The SolarEdge Inline Energy Meter
with SolarEdge Energy Net Communications
The SolarEdge Inline Energy Meter (also referred to as "the inline meter") is used to
measure the power and energy of the photovoltaic (PV) system.
The inline meter:
Fits in a standard EU electrical cabinet
Supports a direct connection of up to 65A per phase, for three phase and single
phase grid connections
Is supplied with integrated current transformers - eliminating the need to install
external CTs
The three phase inline meter (part number: MTR-240-3PC1-D-A-MW) supports both
single-phase and three-phase grid connections.
The single phase inline meter (part number: MTR-240-1PC1-DW-MW) supports single-
phase grids only.
NOTE
This installation guide provides instructions for configuration of the inline meter
using SetApp. To connect the inline meter to display inverters, purchase the
relevant communication board kit from SolarEdge. See Energy Net Support on
page 14 to select the required kit.
SolarEdge Energy Net Wireless Connectivity
The inline meter supports wireless communication with the inverter using the SolarEdge
Energy Net connectivity. To establish communications, the inverter must also support
SolarEdge Energy Net.
Alternatively, serial RS485 connectivity can be implemented.
Package Contents
SolarEdge Inline Energy Meter
NOTE
For the complete list of part numbers that this manual applies to, refer to the
technical specification in the Appendix Supplemental Documentation on page 43.
RS485 Terminal Block
Quick Installation Guide
Inline Energy Meter with SolarEdge Energy Net Communications
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
