Installing And Connecting The Inline Meter - SolarEdge Inline Energy Meter Installation Manual

16 Installing and Connecting the Inline Meter

Installing and Connecting the Inline Meter

NOTE
Make sure the inline meter's rating is within maximum permitted current
limitations.
In export/import applications, check that the rating of the main circuit breaker
is within maximum permitted current limitations.
Mounting the Inline Meter
To mount the inline meter on a DIN rail:
The inline meter is designed for permanent installation in indoor locations. It is
intended for installation in switch cabinets or in small-installation distributors on a 35
mm mounting rail as per DIN EN 60715.
Mount the inline meter on the DIN rail as shown in the figure below. Fit the slot on the
back of the meter over the DIN rail (see steps 1 and 2), and secure it in place on the
DIN rail using the latching mechanism at the bottom of the meter.
To detach the inline meter from the DIN rail:
1. Disconnect all AC wires and RS485 cable (if connected), or Energy Net antenna.
2. Detach the meter from the DIN rail by releasing the lever at the bottom of the meter,
and then separating it from the rail.
Figure 8: Mounting the inline meter on a DIN-rail
Inline Energy Meter with SolarEdge Energy Net Communications