Elkay ezH2O Liv Pro Installation Manual

Elkay ezH2O Liv Pro Installation Manual

Commercial built-in water dispenser 115-120v
Hide thumbs Also See for ezH2O Liv Pro:

Advertisement

Installation Manual
ezH2O® Liv Pro Commercial Built-in Water Dispenser 115-120V
Ambient with Filter Box Configuration
LBWDC00WHC
LBWDC00BKC
Chilled (Optional) with Remote Filter Configuration
(630) 574-8484
Elkay Manufacturing Company
Page 1
1000005449 (Rev. B - 08/21)

Advertisement

Table of Contents
loading

Summary of Contents for Elkay ezH2O Liv Pro

  • Page 1 Installation Manual ezH2O® Liv Pro Commercial Built-in Water Dispenser 115-120V Ambient with Filter Box Configuration LBWDC00WHC LBWDC00BKC Chilled (Optional) with Remote Filter Configuration (630) 574-8484 Elkay Manufacturing Company Page 1 1000005449 (Rev. B - 08/21)
  • Page 2 Elkay Manufacturing Company (630) 574-8484 Page 2 1000005449 (Rev. B - 08/21)
  • Page 3: Table Of Contents

    NOTICE Elkay Manufacturing Company (Elkay) product. Additional instructions could also cause a use and care documents can be found on the Elkay situation that results in water damage, or other website at http://www.elkay.com/support . damage to floors, walls, pipes, or electrical wiring.
  • Page 4: Serial Number Location

    The information contained in this manual is given free of charge. This information is based on reliable technical This product is covered by a Limited Warranty and Elkay data and is intended for people with the technical will not be held responsible for damage of any kind in...
  • Page 5: Safety

    Follow all instructions related to the specifically recommended by Elkay is used, you must be installation and/or maintenance of this product (unit). satisfied that it is safe for yourself and others. You should also make sure that the product will not be damaged by For use with clean, clear potable drinking water only.
  • Page 6: Property Damage

    This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory, or mental capabilities or lack of experience Elkay Manufacturing Company (630) 574-8484 Page 6 1000005449 (Rev. B - 08/21)
  • Page 7: Installation Preparation

    5 . Shut off the water supply source and disconnect or installer for this installation. Professional power to the electrical circuit being used to operate installation is recommended. the product before starting the installation. (630) 574-8484 Elkay Manufacturing Company Page 7 1000005449 (Rev. B - 08/21)
  • Page 8: Installation

    Water Dispenser A) 3-7/8" (97 mm) deep. Filter Unit B) 2-3/8" (61 mm) deep. Elkay Manufacturing Company (630) 574-8484 Page 8 1000005449 (Rev. B - 08/21)
  • Page 9: Water Dispenser Without Filter Box

    If the electrical connection is placed under the unit, a user supplied removable wall cover will be required to access the junction box. (630) 574-8484 Elkay Manufacturing Company Page 9 1000005449 (Rev. B - 08/21)
  • Page 10: Water Dispenser Installation

    . Route the appropriate electrical wiring through a wiring clamp into the gang box. Note: A 1/4 inch offset helps conceal any irregularities at the top of the wall opening. Elkay Manufacturing Company (630) 574-8484 Page 10 1000005449 (Rev. B - 08/21)
  • Page 11: Installation Of Filter Box

    Make sure 3/32 Allen wrench. the filter unit is aligned with the water dispenser. (630) 574-8484 Elkay Manufacturing Company Page 11 1000005449 (Rev. B - 08/21)
  • Page 12: Connecting The Water Lines

    Note: Elkay also recommends installing a shutoff valve Do not disconnect the 1/4" NOTICE at the source of the water supply for the water tubing from the water valve at dispenser.
  • Page 13: Installing Remote Filter

    Remove the four screws that hold the bracket to the filter head. 4 . Connect a 1/4 inch insulated water line, copper or plastic, to the outlet connector of the filter. (630) 574-8484 Elkay Manufacturing Company Page 13 1000005449 (Rev. B - 08/21)
  • Page 14: Installing Remote Water Chiller (Optional)

    The filter can only be installed in one direction (label facing outward). If the red indicator light is ON, the filter is installed backwards. Elkay Manufacturing Company (630) 574-8484 Page 14 1000005449 (Rev. B - 08/21)
  • Page 15: Connecting Catch Basin Waste Drain (Optional)

    Note: Do not use a 1-1/8" hole saw as this will make the Note: Twisting the strainer instead of the drain adapter opening too large. can compromise the seal created by the plumber's putty. (630) 574-8484 Elkay Manufacturing Company Page 15 1000005449 (Rev. B - 08/21)
  • Page 16 . 7 . Place the drain basin back into the water dispenser and reinstall the two screws. Elkay Manufacturing Company (630) 574-8484 Page 16 1000005449 (Rev. B - 08/21)
  • Page 17: Startup

    11 . Enjoy fresh filtered water with your new Elkay ezH2O Liv PRO water dispenser . Note: The water dispenser is set to automatically shut...
  • Page 18 KIT - Filter Box NS = NOT SHOWN I.R SENSOR ASSEMBLY NOTE: Rear view shown with panel cut section Alcove Assembly Rear View of Water Dispenser Fig. 2 Fig. 3 Elkay Manufacturing Company (630) 574-8484 Page 18 1000005449 (Rev. B - 08/21)
  • Page 19 Filter Head Assembly Fig. 4 ALCOVE LEDs Electrical Diagram Fig. 5 (630) 574-8484 Elkay Manufacturing Company Page 19 1000005449 (Rev. B - 08/21)
  • Page 20: Troubleshooting

    Blinking red and blue light. Filter wire disconnected. Check filter cable connections. 7. Frequently Asked Questions (FAQ) For FAQ questions refer to the Elkay website elkay.com/ezh2o-liv. You can find installation and filter replacement videos on Youtube under ezH2O Liv installation and filter replacement.
  • Page 21 Notes (630) 574-8484 Elkay Manufacturing Company Page 21 1000005449 (Rev. B - 08/21)
  • Page 22 Elkay Manufacturing Company (630) 574-8484 Page 22 1000005449 (Rev. B - 08/21)

This manual is also suitable for:

Lbwdc00bkcLbwdc00whc

Table of Contents