Touchpad - HP 16-b0 Series Maintenance And Service Manual

2. Remove the card reader from the computer (2).
Reverse this procedure to install the card reader.

Touchpad

To remove the touchpad, use this procedure and illustration.
Table 5-16 Touchpad description and part number
Description
Touchpad
Touchpad cable
Before removing the touchpad, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the solid-state drives (see
5. Remove the power connector cable (see
6. Remove the heat sink (see
7. Remove the fans (see
8. Remove the system board (see
Remove the touchpad:
1. Remove the four Phillips M2.0 × 2.5 screws (1) from the touchpad bracket, and then remove the bracket
from the computer (2).
Preparation for disassembly on page
Bottom cover on page
Battery on page 32).
Solid-state drive on page
Power connector cable on page
Heat sink on page 39).
Fans on page 41).
System board on page
31).
34).
38).
45).
Component replacement procedures
Spare part number
M62229-001
M57157-001
31).
51