Card Reader - HP 16-b0 Series Maintenance And Service Manual

3. Remove the board from the computer (3).
Reverse this procedure to install the IR sensor board.

Card reader

To remove the card reader, use this procedure and illustration.
Table 5-15 Card reader description and part number
Description
Card reader
Card reader cable
Before removing the card reader, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the solid-state drives (see
5. Remove the power connector cable (see
6. Remove the heat sink (see
7. Remove the fans (see
8. Remove the system board (see
9. Remove the left speaker (see
Remove the card reader:
1. Remove the two Phillips M2.0 × 2.5 screws (1) that secure the card reader to the computer.
50 Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
Battery on page 32).
Solid-state drive on page
Power connector cable on page
Heat sink on page 39).
Fans on page 41).
System board on page
Speaker, right on page
31).
34).
38).
45).
37).
Spare part number
M82357-001
M57155-001
31).