Rgb (Per Key) Board - HP 16-b0 Series Maintenance And Service Manual

Table 5-10 USB board description and part number
Description
USB board
USB board cable
Before removing the USB board, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the solid-state drives (see
5. Remove the heat sink (see
6. Remove the left fan (see
Remove the USB board:
1. Disconnect the cable from the ZIF connector on the board (1).
2. Remove the Phillips M2.0 × 5.0 screw (2) that secures the board to the computer.
3. Lift the board straight up to remove it (3).
Reverse this procedure to install the USB board.

RGB (per key) board

To remove the RGB board, use this procedure and illustration.
Table 5-11 RGB board description and part number
Description
RGB board
44 Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
Battery on page 32).
Solid-state drive on page
Heat sink on page 39).
Fans on page 41).
31).
34).
Spare part number
M82292-001
M82286-001
31).
Spare part number
M64294-001