Power Connector Cable - HP Pavilion 15 Maintenance And Service Manual

5. Lift the top of the touchpad up and into the computer, and then lift it up to remove it (4).
Reverse this procedure to install the touchpad.

Power connector cable

To remove the power connector cable, use this procedure and illustration.
Table 5-13 Power connector cable description and part number
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Remove the battery (see
Remove the power connector cable:
1. Remove the two Phillips M2.0 × 6.5 screws (1) from the right hinge.
2. Rotate the hinge off the power connector (2).
3. Disconnect the power connector cable from the system board (3).
4. Release the cable from the retention clip (4).
(Preparation for disassembly on page
(Bottom cover on page
Battery on page 29).
27).
Component replacement procedures
Spare part number
M08887-001
27).
43