Fingerprint Reader Board - HP 340S G7 Maintenance And Service Manual

Fingerprint reader board

Table 5-8 Fingerprint reader board description and part number
Description
Fingerprint reader board
NOTE: The fingerprint reader board spare part kit does not include the cable. The cable is available as
spare part number L64902-001.
Before removing the fingerprint reader board, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover (see
3. Remove the battery (see
Remove the fingerprint reader board:
1. Disconnect the cable from the ZIF connector on the fingerprint reader board (1).
2. Remove the Phillips M2.0 × 2.0 screw (2) that secures the fingerprint reader bracket to the computer.
3. Remove the bracket (3), and then remove the fingerprint reader board from the computer (4).
Reverse this procedure to install the fingerprint reader board.
(Preparation for disassembly on page
Bottom cover on page
Battery on page 27).
24).
25).
Component replacement procedures
Spare part number
L89228-001
35