Display Assembly - HP 17 Series Maintenance And Service Manual

Display assembly

Full hinge-up displays are not spared. Displays are spared only at the subcomponent level.
Before removing the display panel, follow these steps:
1. Prepare the computer for disassembly
2. Remove the optical drive (see
3. Remove the bottom cover (see
4. Remove the battery (see
Remove the display assembly:
1. Disconnect the antenna cables from the WLAN module (1).
2. Remove the antenna cables from the clips in the speaker and fan (2).
3. Disconnect the display cable from the system board (3).
4. Remove the four Phillips M2.5 × 6.0 screws (1) from the display hinges.
5. Rotate the hinges upward (2).
66 Chapter 6 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
Optical drive on page
Bottom cover on page
Battery on page 40).
33).
37).
32).