Solid-State Drive Bracket And Connector Board - HP 17 Series Maintenance And Service Manual

Solid-state drive bracket and connector board

Table 6-6 Solid-state drive bracket, connector board, and cable descriptions and part numbers
Description
Solid-state drive bracket
Solid-state drive connector board
Solid-state drive cable
Before removing the solid-state drive bracket and connector board, follow these steps:
1. Prepare the computer for disassembly
2. Remove the optical drive (see
3. Remove the bottom cover (see
4. Remove the battery (see
5. Remove the solid-state drive (see
Remove the solid-state drive bracket and connector board:
1. Disconnect the cable from the system board ZIF connector (1).
2. Remove the two Phillips M2.0 × 3.0 screws (2) that secure the board and bracket to the computer.
3. Remove the board from the computer (3).
4. Remove the bracket from the computer (4).
Reverse this procedure to install the solid-state drive bracket and connector board.
(Preparation for disassembly on page
Optical drive on page
Bottom cover on page
Battery on page 40).
Solid-state drive on page
33).
37).
46).
Component replacement procedures
Spare part number
L22535-001
L22542-001
L22527-001
32).
47