Table of Contents
Advertisement
ZS4000 High-Impedance Active Probe
Safety Instructions
Observe generally accepted safety procedures in addition to the precautions
listed here. The overall safety of any system incorporating this accessory is
the responsibility of the assembler of the system.
Symbols
These symbols appear on the probe body or in documentation to alert you to
important safety considerations.
CAUTION of potential for damage to equipment, or WARNING of
potential for bodily injury. Attend to the information, and do not
proceed until conditions are fully understood and met.
ELECTROSTATIC DISCHARGE (ESD) HAZARD. The probe is
susceptible to damage if anti-static measures are not taken.
Precautions
Connect and disconnect properly. Connect probe to the measurement
instrument before connecting the test leads to a circuit/signal being tested.
Use only within operational environment listed. Do not use in wet or explosive
atmospheres.
Use indoors only.
Keep product surfaces clean and dry.
Be careful with sharp tips. The tips may cause bodily injury if not handled
properly.
Use only accessories designed for use with the product.
Observe all terminal ratings. To avoid electric shock or probe damage, do not
use the probe above the input limits shown on the probe.
Do not excessively bend cables.
Do not operate with suspected failures. Do not use the probe if any part is
damaged. Cease operation immediately and secure the probe from inadvertent
use.
2
Advertisement
Table of Contents
