Quick Installation Guide
TL-WPA4220 KIT
* TL-WPA4220 KIT (European version) is
used for demonstration in this QIG.
e
r l i n
w e
P o
LAN
Router
Extender
TL-WPA4220
2
Plug in the adapter and extender in the
Adapter
same room. Wait for about 20 seconds
TL-PA4010
until the extender's Wi-Fi LED
on.
Note: If only one wall outlet is available, plug both
devices into a power strip for setup, then relocate
to wall outlets before enjoying the internet.
1
3
Pair the powerline devices.
A
Press the adapter's Pair button for 1 second.
The Power LED
starts blinking.
Note: If the LED does not blink, press the
button again.
On
Adapter TL-PA4010
4
Relocate the extender to the Wi-Fi "dead" zone on the same electrical circuit. Connect your devices
to the internet using the default SSID (network name) and password on the Wi-Fi Info Card provided.
Note: If the Powerline LED turns red, it means the signal strength is poor. Try another wall outlet.
turns
Attention
Plug powerline devices into wall outlets. Do not use power strips after setup.
Wall Outlet
B
Within 2 minutes, press the extender's Pair button for 1 second.
The Power LED
starts blinking.
When the Powerline LED
turns on, the pairing process is
complete.
Blinking
Within 2 minutes
Extender TL-WPA4220
Tips:
Want to unify Wi-Fi networks or
personalize your network?
See the back page for instructions.
Power Strip
Blinking
On