TP-Link NC450 Quick Installation Manual

Wall Mounting
1
Place the paper drill guide where you want
the camera. Check the alignment using
a level. Using a 0.24 inch (6mm) drill bit, drill
holes through the two circles on the guide.
Remove the paper.
2
Insert the two anchors into the holes and
place the camera mount over the anchor.
3
Attach the camera and use the screws to
secure it.
Ceiling Mounting
1
Place the paper drill guide where you want
the camera*. Using a 0.24 inch (6mm) drill
bit, drill holes through the two circles
on the guide. Remove the paper.
* Camera placement can affect viewing angle. For best
results, place the camera near a wall or corner.
2
Attach the camera mount using the
screws, washers and wingnuts.
3
Attach the camera and use the screws to
secure it.
Quick Installation Guide
1
Connect
Connect the NC450 and your smartphone
to the same router, then connect the power
cord and internet cord to the NC450. If the
cord is long enough, please use Method A
below. If not, use a Passive PoE Injector to
connect, as shown in Method B.
Smartphone Internet Wireless Router
WAN LAN
A
Camera Camera
Outlet Outlet
Passive
POE
Injector
System LED
Flashing red: System starting
Solid red: Network not connected
Solid green: Network connected
More functions with tpCamera
Get notifications when motion is
detected, and view alerts history.
Stay in touch with 2-way audio.
View all of your cameras on one screen by
downloading the TP-Link Camera Control
utility. See the Camera Control User Guide
for more details. Or visit us online at
www.tp-link.com for Camera Control utility,
Firmware, and other support.
1
Drill Holes
1
Drill Holes
2
Register
Download the tpCamera app. Once installed,
open it and follow the instructions to add
the camera to your TP-Link ID.
OR
B
The WPS/Reset Button
WPS (Wi-Fi Protected Setup): If your Wi-Fi
router supports WPS, you can connect the
camera to your Wi-Fi network using WPS.
For details, see the camera's User Guide.
WPS/
RESET
Short Press to trigger WPS; Press and
hold for 5 seconds to trigger Reset.
2
Mount Base
2
Mount Base
3
Relocate
Place the camera where you want it. You can
place it on a flat surface, or mount it as shown
on the back of this guide.
Mounting Kit
Camera Base Wall mount kit
3
Secure Camera
3
Secure Camera
4
View and Enjoy
View live video using the tpCamera
app or TP-Link Cloud website.
Via tpCamera: On the "My Cam" screen,
tap your camera to view video. Change the
camera angle using the pan and tilt
controls.
Via TP-Link Cloud website: Log in at
https://www.tplinkcloud.com and select
your camera to view live video.
Support
For technical support and other information,
please visit http://www.tp-link.com/support.
Ceiling mount kit
©2017 TP-Link