Table of Contents
Advertisement
h.
If it is necessary to replace the display panel bracket, remove the bracket.
The display panel bracket is available using spare part number L14337-001.
12.
If it is necessary to replace the display back cover:
a.
Remove the display bezel.
b.
Remove the display panel.
c.
Remove the following screws that secure the back cover to the display hinges:
(1) Two Phillips M2.0×2.8 screws on the back cover top edge
(2) Four Phillips M2.0×3.0 broad head screws on the display hinge outside edges
(3) Two Phillips M2.5×4.7 screws on the display hinge inside edges
d.
Release the display panel (4) as far as the webcam/microphone module cable allows.
e.
Release the webcam/microphone module cable (5) from the retention clips and routing channel built
into the display back cover.
46
Chapter 5 Removal and replacement procedures
Advertisement
Table of Contents
