Table of Contents
Advertisement
NOTE:
The WLAN antenna cable labeled "1/MAIN" connects to the WLAN module "Main" terminal. The
WLAN antenna cable labeled "2/AUX" connects to the WLAN module "Aux" terminal.
2.
Remove the Phillips PM2.0×2.9 screw (2) that secures the WLAN module to the computer. (The WLAN
module tilts up.)
3.
Release the shielding material (3) that secures the WLAN module to the slot.
NOTE:
The WLAN module shielding material is included in the Mylar Kit, spare part number L14346-001.
4.
Remove the WLAN module (4) by pulling the module away from the slot at an angle.
NOTE:
WLAN modules are designed with a notch to prevent incorrect insertion.
Reverse this procedure to install the WLAN module.
Component replacement procedures
29
Advertisement
Table of Contents
