Connecting The Inverter To Ac Grid; Connecting The Dc Strings To The Inverter - SolarEdge Energy Bank Installation Manual

32 Connecting the Inverter to AC Grid
Connecting the Inverter to AC Grid
For connecting the inverter to AC grid, use a 1–10 mm
For more wiring information, refer to the SolarEdge Recommended AC
Wiring Application Note , available on the SolarEdge website at
http://www.solaredge.com/files/pdfs/application-note-recommended-
wiring.pdf.
To connect to AC grid:
1. Turn off the AC circuit breaker on the distribution panel.
2. Strip 2.5'' / 60 mm of the external cable insulation and strip 0.6'' / 15 mm of the
internal wire insulation.
3. Pass the AC cable through the conduit.
4. Connect the wires to the AC terminals as shown below.

Connecting the DC Strings to the Inverter

Connect the string to the DC input pairs. If required, connect additional strings in
parallel using an external combiner box/branch cables before connecting to the
inverter.
Figure 11: Insulation Stripping – AC Cable
Figure 12: AC connection
Single Phase Energy Hub Inverter MAN-01-00812-1.1
2
cable.