Moen MicroTech 9000 Replacement Instructions

MicroTech ® 9000 Filter Replacement
Instructions
For PureTouch® AquaSuite™ Water Filtration System, (77100 Series)*
Instrucciones para Reemplazar el Filtro 9000
Para el sistema de Filtrado de Agua PureTouch
Directives de remplacement du filtre MicroTech
9000
Pour système de filtration de l'eau AquaSuite
HELPLINE: 1-877-DRINK-H2O
(1-877-374-6542)
Au Canada 1 800 465-6130
Filter Installation / Replacement
AquaSuite
Faucet
Filter Life
Indicator Light
1. The filter needs to be replaced
when the Filter Life Indicator
Light begins to flash red. A
flashing amber light indicates
less than 8% filter
remaining.
2. Turn off water pressure by
closing the Stop Valve (1) (open
position shown) next to the
Filter Life Indicator Module (2).
CAUTION: The Stop Valve
!
must be closed before
removal of filter.
3. Next, turn the AquaSuite faucet
handle to the full 'ON' position
for several seconds to relieve
any remaining water pressure,
then turn back 'OFF'.
*
(Faucet model number may contain a suffix that denotes a product color)
INS415 MAR 2001
MC
LÍNEA DE AYUDA:
1-877-DRINK-H2O
(1-877-374-6542)
En Canadá 1 800 465-6130
4. Rotate the filter (4) by moving the arrow from the
locked position until it comes to a complete stop
in the unlocked position.
5. Pull the filter down and out of the Filter Mounting
life
Bracket. It is normal for a small amount of water
to drip from the mounting bracket when the filter
is removed.
6. Remove new filter from packaging and install by
reversing steps 4 and 5 above.
7. Turn on water pressure by opening the Stop
Valve.
8. Turn the AquaSuite faucet lever to the full 'ON'
position for several seconds to confirm proper
operation of the filter and turn back 'OFF'.
CAUTION: Air pressurization of the filter
!
occurs once the stop valve (1) is opened
following a new filter installation. Make sure
to relieve the pressure in the system by
opening up the AquaSuite faucet valve after
you open the stop valve on the Filter Life
Indicator Module.
® AquaSuite™ (Serie 77100)*
PureTouch ® (série 77100)*
SERVICE À LA CLIENTÈLE :
Locked Position
Unlocked Position
®
1 800 465-6130
9. Reset the Filter Life Indicator Module by pushing the
reset button (5) on the Filter Life Indicator Module.
10. A new filter must be flushed with cold water for 5
minutes after it is installed. This procedure helps
clean the filter of loose carbon particles. The Filter
Life Indicator Lights will alternate green and amber
until flushing is complete. Once completed, the light
will change to flashing green.
11. Filter replacement complete.
MicroTech Replacement Filters
• Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after the system. Systems
certified for cyst reduction may be used on
disinfected waters that may contain filterable cysts.
• Replacement filters can be purchased at retail home
centers, plumbing supply warehouses, internet
retailers and directly from Moen at www.pure-
touch.com.
Other Foreign and Domestic Patents Pending
INS415
Reset Button
U.S. Patent Pending