Table of Contents
Advertisement
MAINTENANCE
Cleaning
Clean the outside of the WavePulser using a soft cloth moistened
with water or isopropyl alcohol solution. Do not use harsh or abrasive
cleansers. Dry thoroughly before using. Do not submerge the instrument
or allow moisture to penetrate it.
CAUTION. To avoid electric shock, unplug the WavePulser before
cleaning it. Do not attempt to clean internal parts.
Regularly remove the cables and clean the connector heads with an
alcohol solution to remove any dirt from handling. Dry them thoroughly
before reconnecting. Keep exposed cable connectors and the WavePulser
ports covered with the supplied end caps when not in use. Any dirt that
accumulates in the connector heads will impair measurements.
CAUTION. Do not clean cable connectors while attached to the
WavePulser.
32
933197-00 Rev A
Software Updates
Free updates are available periodically from the Teledyne LeCroy website
at teledynelecroy.com/support/softwaredownload. Registered users will
receive email notification when a new update is released.
1. Visit the software download page at the URL above and click the link
to WavePulser Downloads > WavePulser Software.
2. Enter the required model information and account login. If you don't
yet have an account, create one now.
3. Follow the instructions to save the installer to a location on the host.
4. Close the WavePulser application.
5. Shut down the WavePulser unit and disconnect it from the PC.
6. Unzip the installer file and double-click WavePulserInstallerxx.exe to
launch the WavePulser Setup Wizard.
7. Follow the wizard prompts. We recommend taking the full installation.
At minimum, you will need the WavePulser application and the drivers.
8. When installation is complete, power down the host and repeat the
initialization procedure on p.8.
CAUTION. The installation may take several minutes, depending on
the length of time since your last update. Do not power down the
host at any point during the installation process.
Advertisement
Table of Contents
