Table of Contents
Advertisement
To manually upload a firmware file to your extender:
1. Download the firmware file for your extender from the NETGEAR Download Center,
save it to your desktop, and unzip the file if needed.
Note: The correct firmware file uses an .img extension.
2. Launch a web browser from a computer or mobile device that is connected to your
extender network.
3. Log in to your extender:
• If you did not enable the One WiFi Name feature, enter www.mywifiext.net in
the address field of the browser.
• If you enabled the One WiFi Name feature, enter one of the following URLs:
-
Windows-based computers. http://mywifiext/ or http://mywifiext.local/
-
Mac computers, iOS devices, and Linux devices. http://mywifiext.local/
-
Android devices. http://<extender's IP address>/ (for example,
http://192.168.1.3/)
For more information about how to find your extender's IP address, see Find
the Extender's IP address on page 69.
A login page displays.
4. Enter your admin user name and password and click the LOG IN button.
The Status page displays.
5.
If your browser displays the Menu icon
The extender menu displays.
6. Select Firmware Update.
The Firmware Update page displays.
7. Click the BROWSE button.
8. Locate and select the new firmware file.
The firmware file name ends with a .img extension.
9. Click the UPLOAD button.
CAUTION:
After you click the UPLOAD button, do not try to go online, turn off the
extender, shut down the computer, or do anything else to the extender until it finishes
restarting.
Maintain and monitor the
extender
Nighthawk AX8 8-Stream WiFi 6 Mesh Extender
, click it.
51
User Manual
Advertisement
Table of Contents
