Long range, high perfomance wifi extender/wifi extender+4g lte (13 pages)
Summary of Contents for Winegard Togo Roadlink C2
Page 1
SCAN QR code with App for Setup QR code found in manual For help, email help@winegard.com or call 1-800-320-9992. ® For help relating to your AT&T Data plan please call 1-800-331-0500 Register your product at winegard.com/myantenna Place label here...
Information provided in this manual was accurate at time of printing. If the Roadlink C2 antenna does not function as expected, please contact Winegard Company at 1-800- 320-9992, email help@winegard.com, or visit our website at www.winegard.com/connect.
Parts List Antenna 20’ Power Cable Power Switch Tools required for unpacking & installation: • Drill with 3/4” bit • 1-1/4” hole saw (if mounting Wall Plate switch in wall) • Phillips screw driver #2 3/8” • Sealant (consult RV manufacturer for proper type for Wall Plate Screw (2) your roof material)
Page 4
Togo Roadlink C2 Installation (cont) ™ Exterior STEP 1 – Select a level spot on your roof for installation. Level the base front-to-back and side-to-side. STEP 2 – After selecting a location for the antenna, make sure that the centerline of the antenna is on or parallel to the centerline of the vehicle;...
Page 5
Togo Roadlink C2 Installation (cont) ™ Vehicle's Roof +12V DC RED WIRE - TO SWITCH 3A FUSE RECOMMENDED BLACK WIRE - TO GROUND STEP 10 STEP 11 ON Position On/Off Rocker Power switch Switch (shown into wall plate in Off Position) STEP 12 &...
Do not connect directly to the local network (shown on the front of this manual) of your Togo Roadlink C2 Device. You will be instructed when to connect during the initial account setup process.
Page 7
Please scan the Winegard code and complete the registration process. NOTE: If you are unsure of where the QR code is located, please contact Winegard or your vehicle manufacturer. Also, if your camera does not appear to operate properly, make sure that the Winegard Connected app has access to your device’s camera.
Page 8
Device Information. Verify that the Network Name and Network Password match what is labeled on your manual (if it is not please stop and confirm the device is powered on or contact Winegard Company at 1-800-320-9992). Next, open up your device’s wireless settings and select the correct Network Name (ex.
Roadlink C2 unit. Click on the Close button. 14. Be sure that your device is connected to the Togo Roadlink C2 system and that your Internet source is 4G as shown below. Once the Signal Strength indicator shows a signal and you are connected to Togo Roadlink AT&T, you are ready to use the previously purchased...
Page 10
If no internet connection is available, the file can be saved to your device and sent via email at a later time. Product Manual – This link will send you to the Winegard website where you can find your correct manual. Submit Help Request –...
1. Located on the side of the dome is a SIM card /LED cover plate. Inside this plate there will be a white password label with your factory preset SSID and password. 2. Contact Winegard at 1-800-320-9992. If you have changed your password you have 3 options: 1. Inside the SIM Card/LED cover plate there is a reset button on the left hand side.
Disclaimer: Although every effort has been made to ensure that the information in this manual is correct and complete, no company shall be held liable for any errors or omissions in this manual. Information provided in this manual was accurate at time of printing. If the antenna does not function as expected, please contact Winegard Co. Winegard Company Winegard is a registered trademark of Winegard Company.