Water Pressure - BRP Evinrude E-TEC 40 Operator's Manual

1. Main cable
2. Starwasher
3. Accessory wires
Tighten all connections securely and coat the
installation with Triple-Guard grease.
Service
Battery electrolyte is acidic — handle
with care. If electrolyte contacts any part
of the body, immediately flush with water
and seek medical attention.
Do not use a booster battery and jumper
cables to start the outboard. Gasoline
fumes can cause explosion and fire,
resulting in property damage, personal
injury or death.
DR6496
Service electrical components only while
the outboard is NOT running. Be careful
when identifying positive and negative
battery cables and posts.
Before servicing the battery or the outboard,
remove both battery cables from the battery,
battery negative (–) cable first. Keep metal
objects from contacting either battery post.

Water Pressure

An optional water pressure gauge is recom-
mended to monitor cooling system pressures.
Noticing changes in water pressure can help
prevent engine overheating. The water pres-
sure gauge must be connected at the correct
DR5104
point to ensure the most accurate pressure
readings. Follow the installation instructions
included with the water pressure gauge.
1
1. Water pressure port (behind fuel filter)
2. Fuel filter
Installation

WARNING
NOTICE
2
002166
002009
73