Table of Contents
Advertisement
Beacon Interval
DTIM Period
Channel Width
Preamble Type
Broadcast ESSID
WMM
CTS Protect
TX Power
Enable LED off mode
When you complete the settings in this page, click the 'Apply' button. You'll see the
following message:
Set the beacon interval of wireless radio. Do not modify
the default value if you don't know what it is. The default
value is 100.
Configures DTIM (Delivery Traffic Indication Message)
send period. The default value is 3.
Set channel width of wireless radio. You can modify the
default value if you know what channel width you need,
default setting is 'Auto 80MHz'.
Set the type of preamble of wireless radio. Do not modify
the default value if you don't know what it is. The default
setting is 'Short Preamble'.
When set to 'enabled', every wireless device can scan
and find this Wireless Mesh Point; when set to 'disabled',
only wireless clients who know the exact SSID can get
connected with this wireless Mesh Point. Set to disabled
will help to improve security.
Enable or disable Wireless Multi-Media. When enabled,
the Wireless Mesh Point will give priority to multimedia
related network applications so they will have better
performance.
This function provides CTS (Clear to Send) protection
when transferring data. It's recommended to select
'Auto' for this option.
Select the wireless transmitting power level, from 10%
to 100%. When wireless clients are not too far from this
Wireless Mesh Point, you don't have to select a higher
power level, since this may cause some individuals to
attempt to break into your wireless network if you have a
bad password or no password.
You can enable or disable LED lights. Check 'Enable LED
OFF' mode to setup LED behavior:
Turn off all LED: disables all LED lights.
Turn off all LED except POWER LED: all LED lights will be
disabled, except the 'POWER' LED.
69
Advertisement
Table of Contents
