Comtrend Corporation WAP-5922 User Manual page 40

TX Power
Enable LED off mode
When you finish the settings in this page, click the 'Apply' button. You'll see the
following message:
If you still need to configure this Wireless Mesh Point, click the 'CONTINUE' button;
if you want to save the changes and use it now, click the 'APPLY' button.
You'll be prompted to wait for 50 seconds before you can reconnect to this Wireless
Mesh Point.
After the countdown click the 'OK!' button.
Select the wireless transmitting power level, from 10%
to 100%. When wireless clients are not too far from this
Wireless-N Range Mesh Point, you don't have to select a
higher power level, since this may cause some
individuals to attempt to break into your wireless
network if you have a bad password, or no password.
You can enable or disable LED lights. Check 'Enable LED
OFF' mode to setup LED behavior:
Turn off all LED: disables all LED lights.
Turn off all LED except POWER LED: all LED lights will be
disabled, except the 'POWER' LED.
39