Table of Contents
Advertisement
You can check the 'Signal' LED status to understand signal reception level.
(Please see the table on page 14 for details.)
If the Signal LED is off, it means the device is out of wireless range of your
wireless broadband router or access point. Move the Mesh Point closer to the
broadband router until the Wireless Mesh Point device can receive a signal from
the broadband router and extend its signal.
The quick installation setup is complete, you can refer to '3.2 Repeater mode
Advanced Settings' to login to the web user interface for other advanced
settings.
3.1.2 Web browser quick setup
Before you can connect to the Wireless Mesh Point and start the configuration
procedures, your computer must be able to get an IP address automatically (use
dynamic IP address). If it's set to use a static IP address, or you're unsure, please
refer to 'Chapter 6: 6.1 Configuring TCP/IP on PC' to set your computer to use
dynamic IP address.
1.
Use an Ethernet cable to connect your computer's Ethernet port and the
wireless Mesh Point's Ethernet port.
Or use your computer's wireless configuration utility to search for an access
point named 'repeater0003' and get connected. (The default SSID of this
Wireless Mesh Point device is 'repeater0003', 0003 is for reference, it is the
last 4 digits of the device's MAC number. Each device has a different MAC
number; please find it on your device label.)
24
Advertisement
Table of Contents
