Table of Contents
Advertisement
Chapter 2 Mesh WiFi-Supported Installation
Scenario 1: Using a Comtrend Mesh WiFi-Supported Gateway
Use anywhere from 1-10 Mesh Points on a single network.
Scenario 2: Using a Non-Comtrend Mesh WiFi-Supported Gateway
Use anywhere from 2-10 Mesh Points on a single network.
Note: A minimum of 2 Mesh Points are required to create a connection for this
scenario.
2.1 Device Setup
The following steps show how to setup your Whole-Home WiFi Mesh System
using Ethernet Pairing. For additional setup options (including WPS), please refer
to the User Manual available online.
NOTE: If you are using a Comtrend WiFi Mesh-Supported Gateway, then the
Mesh Points will work in conjunction with your Gateway's WiFi. If you are not
using a Comtrend WiFi Mesh-Supported Gateway, then the WiFi Mesh Points will
create a separate WiFi Mesh System (Note: This application will require at least
two WiFi Mesh Devices to create a Mesh System).
1. Connect one end of an Ethernet Cable into each Mesh Point (WAP-5922) that
you wish to have in your Whole-Home WiFi Mesh System. For this example, we
will use two Mesh Points.
2. Plug the Mesh Points into an outlet near your Network Device (Router,
Modem).
Ethernet
Cable
Steps 1-2
16
Advertisement
Table of Contents
