Table of Contents
Advertisement
LED1 off
LED2 off
LED3 on
LED1 LED2
LED3
flashing
Power
LED 4 on
LED4
flashing
LED4 off
3. The device is in repeater
mode, when LED1 & 2 are off
and LED3 is on. It indicates the
current placement is too far
from the uplink router, which
potentially makes the uplink
connection weak and may
result in slow speed or
disconnection.
1. The device is not with a stable
connection. It may be in the
progress of pairing, grouping,
and or synchronising.
2. The device will not be able to
configure before these 3 LEDs
stop flashing.
The device is powered on.
Firmware upgrading is taking
place.
Device is powered off or no power.
14
signal too weak:
< -60dBm
The device in
factory default and
powered (with
power LED on), in
this state, it is not
ready to make any
configuration, and
it needs to wait
until LED1, 2 & 3
are flashing.
(If only the power
LED on, the
Wireless Mesh Point
is still in booting
process.)
Advertisement
Table of Contents
